![]() ![]() With wrench, tighten nut 2 turns past finger tight. Do not overtighten. NOTICE: Failure to use plastic sleeve in the correct orientation will result in disconnection and possible water damage.ĥ. Slide plastic sleeve down tube until it engages top of fitting. Tube should touch bottom of hole inside fitting.Ĥ. Slide nut (2) and plastic sleeve (3) onto cut tube. Leave 1" - 2" of extra length to allow for easier installation, and cut tube. Instructions: Watch this how-to video for information on how to cut your PEX supply lines to size.ġ. Should my water lines at the kitchen sink be flushed prior to the installation. Do not use pipe dope or other sealants on water line connections. What hole size is required to install a BLANCO faucet into a countertop. The Design House Faucet Extension Kit extends water supply line tubes by 1. Pointer: also a great tool when your roommate is being annoying and needs a good hose down. NOTICE: DO NOT use a metal sleeve, RP51243 gasket (supplied with faucet) or ferrule in the place of the plastic sleeve supplied-it may not create a leak-free joint. Shop Design House Kitchen Faucet Water Supply Line Extension Kit in the Supply Line Accessories department at. No matter what size of faucet supply line you need, they all include FIP (female) hex. See plastic sleeve installation instructions found on RP50952. You can use faucet supply lines in both the bathroom and the kitchen. Delta is not responsible for tubing that is cut too short or cut in a way that will not allow for a leak-free joint. For custom fit installations, you must use RP50952 sleeves supplied with model and nuts included on supply lines. Tube cut must be straight. If you detect a slight drip, use a wrench to tighten the connections until the leak stops, but do not over-tighten. Then, carefully check to make sure there are no leaks. ![]() Test out the operation of your faucet and sprayer. assume a waterfall of water will cascade from each faucet and hose bib. With the water supply lines connected, turn the water back on at the hot and cold valves. When cutting the supply tubing, the installer accepts the responsibility to do so in a way that allows a leak-free joint to be created. Size water line - The red arrows point to a large-diameter 1-inch feed line for. ![]() Delta Faucet Company recommends you leave the existing fitting on the PEX supply tubing and not shorten the tubing. If you determine the PEX supply tubing for this faucet is too long and must be shorter to create an acceptable installation, be sure to read the instructions and plan ahead. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |